1. Change the water in the water cooler once a month. It is best to change to distilled water. If distilled water is not available, pure water can be used instead.
2. Take out the protective lens and check it every day before turning it on. If it is dirty, it needs to be wiped.
When cutting the SS, there is a slight point in the middle of the protective lens, and it needs to be replaced with a new one. If you cut MS, you have to change if there is point in the middle, and point around lens doesn’t have much impact.
3. 2-3 days need to be calibrated once
4. It is best to use nitrogen for cutting thin plates. If cutting with oxygen, the speed is almost 50% slower. Oxygen can also be used to cut galvanized sheet of 1-2 mm, but slag will be formed when cutting more than 2 mm.
5. The Raycus laser is not controlled by a network cable, but a serial cable that can be plugged in.
6. When setting the focus, oxygen is set to positive focus, and nitrogen is set to negative focus. In the case of inability to cut through, increase the focus, but when cutting SS with nitrogen, increase the focus to the negative direction, which is equivalent to decreasing.
7. Purpose of the interferometer: There will be a certain error in the operation of the laser machine, and the interferometer can reduce this error.
8. The XY axis is automatically filled with oil, but the Z axis needs to be manually brushed with oil.
9. When the perforation parameter is adjusted, there are three levels
It need to adjust the first-level parameters when the board with 1-5mm, it need to adjust the second-level parameters 5-10mm, and the board above 10mm it need to adjust the third-level parameters. When adjusting the parameters, adjust the right side first and then the left side.
10. The protective lens for RAYTOOLS laser head is 27.9 mm in diameter and 4.1 mm in thickness.
11. When drilling, the thin plate uses a higher gas pressure, and the thick plate uses a lower gas pressure.
Post time: Oct-08-2022
